Timbabuild Epoxy Wood Stabiliser is a specially designed two-part low viscosity, solvent free, resin primer which is designed to strengthen weakened wood fibres by penetrating deep into the wood.
EWS is designed to be used as a primer in conjunction with the Epoxy Rapid Cure (ERC10) or Epoxy High Build (EHB60) systems. Once the damaged, decayed and discoloured wood has been removed by use of a suitable cutter tool such as a router or chisel, then the area to be treated is lightly sanded to ensure excellent adhesion. The moisture content of the wood should be no greater than 18% (check using a standard moisture meter) and damp wood should be allowed to dry naturally, or by way of a hot air gun. The two components are mixed manually into a separate container, and thoroughly agitated for one minute. The 2:1 mixing ratio should be strictly observed. EWS should be applied using a standard brush and left to cure for at least 20 minutes.
Use disposable paint brushes - cleaning is not possible after use.
Timbabuild EWS wood Stabiliser 225ml- RRP $44.12 + GST
Key benefits
• Solvent Free - suitable for indoors and outdoors
• Excellent Penetration due to the Low Viscosity
• Pre-measured to Volume 2:1 ratio to ensure accurate mix
• High Strength & Durability
• Fast and Simple to Use, Easy to Clean and Store
• Used with both the ERC10 & EHB60 systems
Estimated* Coverage:
Substrate
Coverage per 225ml pack (m2)
Hard wood
2.0
Soft Wood
1.5
Damaged Wood
1.0
Akron trade centre
69 O, Rorke Road
Auckland 1061
Tel. 0800 225581
Email: sales@akrontradecentre.co.nz
Colorex
7 Fitzherbert St, Petone, Wellington
Ph: 0800 587 0400
Email: sales@colorex.co.nzTrade extra
3 Glenmore Drive
Warkworth
North Auckland 0910Email : orders@tradextra.co.nz
Telephone: 0800 425 800
Telephone: (09) 425 0235